Need help?

(Live chat)

or Emai us: sale@vibratingscreen.cc

Hot Product

Contacts

+86-15136770681

sale@vibratingscreen.cc

+86-373-3669006

From West Room 5, 1st Floor, Building 18, Huilong Yangguang Mingyuan, New District, Xinxiang, Henan, China (Mainland).

Your Position:Home > Faq

How to Solve The Problem of Slow Discharge of Rotary Vibrating Screen

The three-dimensional rotary vibrating screen is usually also referred to as a vibrating screen for short. It is a common series of light screening products that can effectively screen, remove impurities and classify powder, small particles and liquid materials. Some users of the rotary vibrating screen encountered the problem of slow discharge of the sieve during use. For this problem, the user can refer to the solution.

1.If it is a new equipment, this problem occurs at the beginning of use. Check whether the screen of the rotary vibrating screen and the discharge port are at the same level. If the screen and the discharge port are not level, it will cause the rotary vibrating screen to discharge. If the problem of clutter and slowness occurs, it is a quality problem of the rotary vibrating screen, and the manufacturer should be contacted and asked to repair it.

2.Check whether the entire rotary vibrating screen is working in a horizontal state. If the entire equipment is not on a horizontal surface, the problem of slow impurity removal by the rotary vibrating screen will occur, which affects the screening efficiency. This problem can be solved by adding or reducing a shock-absorbing foot.

3.If none of the above two problems exist, you can adjust the angle of the eccentric block of the vibration motor of the rotary vibrating screen to change the speed of the material moving on the screen surface. The smaller the angle, the faster the material will spread out; The larger the angle, the slower the material will spread out, and the angle of the eccentric block of the vibration motor should be kept ≥5° each time. In addition, if the angle of the eccentric block of the vibration motor is too small, it will affect the accuracy of the screening, so the user should adjust it according to the condition of the material and the requirements of the screening accuracy.

Pre:Rotary Vibrating Screen That Can Be Equipped With Iron Remover

Next:Analysis of The Jamming Failure of Screw Conveyor